SPRT SP-L36 - 3.6.3 WiFi Connection

10
Please see details in primary device Bluetooth function instruction for
reference.
Notice:
1. When pairing, please make SP-L36 BT switch on.
2. Once SP-L36 has paired with the host successful, it can’t be paired with
other Bluetooth device until it unconnected with the host.
3. The power indicator flashing after paired successful. Printer LCD shows the
connection state.
3.6.3 WiFi connection
Handheld devices with WiFi interface can be connected to a printer via
WeChat for printing. The method of use is as follows:
1. Plug in the printer power and press the power button to make the printer
power on.
2. Connect the mobile phone or tablet to a networkable router.
3. If the printer has never established a connection with this router, you
need to first configure the network to connect the printer to the router.
Distribution method: Press and hold the printer's FEED button for more
than 3 seconds, the printer will print out the QR code and follow the WeChat
prompt to enter the router's password to configure the network.
4. After successful network configuration, the printer will print "Exit Network
Configuration Mode", indicating that the printer has been successfully
connected to the router. At this time, WeChat will scan the available printers in
the local area and select the printer that has just been configured. Successfully
bound the printer to WeChat and will enter the SPRIT public account. If you
don't need to change the router, you don't need to configure the network, you
can directly enter the SPRUI official account. You can also scan the QR code
on the bottom label of the machine and follow the prompts to skip the network
configuration step and enter the public account directly.
3.7 Buzzer
There is also a buzzer to indicate various status of the printer. The meanings
are as below:
One low one high: power on;
One high one low: power off;
Circulation continuous two lows: printer at mistakes status