SPRT SP-L36 - 2.2 Physical Parameters; 2.3 Environment

3
CODABAR,CODE93,CODE128
2D Barcode: PDF417,QR CODE,DATA Matrix
2.2 Physical Parameters
Dimension: 123(L)X112(W)X67(H)mm
Physical Weight: 436g (excluding roll paper)
Paper Roll Diameter: ≤ 50.0mm
Interface: USB, Bluetooth, WiFi
2.3 Environment
Operating Temp: -20℃~50℃
Operating Humidity: 10%~80% ( relative humidity)
Storage Temp: -20
℃
~60
℃
Storage Humidity: 10%~90% ( relative storage humidity)
2.4 other Specification
● Paper Loading Method: drop-in easy loading（please refer to details in
3.1.2 Paper Roll Installation).
● Paper Tearing Method: Manually tearing
● Black Mark Location: available(details please see 4.2 pre-printed black
mark manual).
● Printing Control Command: ESC/POS compatible command set/CPCL
command set. (Pls refer to the details in “The Commands Manual of SP-L36”).
● Power Supply: 7.4V/2100mAh rechargeable polymer lithium battery.
● Low Power Alarm: When the electric of battery will run out, the battery
icon in the printer screen will flash.
● Battery Charging: quick charging, it will be charged full about 4hours;
● Auto-sleeping: If the printer doesn’t receive any data or no any buttons
operation within 5seconds, the printer will go into the auto-sleeping mode.
During auto-sleeping, press any buttons on the printer or the printer receives
any data will call the printer on.
● Battery Duration: under25% printing density ,at least 200 meters, the
standby time is over 4days. These parameters are just for reference, long term
usage will cause the capacity decline, and can not ensure the time of printing.