SPRT SP Series - Chinese Print Control Commands

45
These data will be printed out in hexadecimal:
00 1B 41 18
Hexadecimal print mode carries out print only when the print buffer is full.
4.2.8 Chinese Character Print Control Commands
Chinese character print commands adopt FS standard commands. The Chinese
character library is the level I, II Chinese characters, graphics and symbols which all meet the
specifications of GB2312-80. Each Chinese character or character is presented by 2-byte GB code.
This series adopt internal code which is corresponding GB code to denote the Chinese characters.
Notice：only the commands with * are effective in series CF and TF, and only receive Chinese
command and CR、LF.
The following is the description for these commands.
FS & *
Select Chinese Print Mode*
Format：ASCII： FS &
Decimal： 28 38
Hexadecimal： 1C 26
Explanation：
After printer received this command, it will switch from ASCII character print mode to Chinese
character print mode. Using GB Chinese character library level I, II.
FS · * Cancel Chinese Print Mode*
Format： ASCII： FS ·
Decimal： 28 46
Hexadecimal： 1C 2E
Explanation：
After printer received this command, it will switch from Chinese character print mode to character
print mode.
FS SO *
Set Chinese Double Width Print*
Format：ASCII： FS SO
Decimal： 28 14
Hexadecimal： 1C 0E
Explanation：