47
Hexadecimal： 1C 49 n
Explanation：
This command is to rotate Chinese characters, the values of n are as
following:
n
Chinese characters
rotated widdershins
0 0°
1 90°
2 180°
3 270°
FS - Chinese Character with Underline Print
Format： ASCII： FS - n
Decimal： 28 45 n
Hexadecimal： 1C 2D n
Explanation：
The specified Chinese characters after this command are printed with
underline. When n=1, underline selected; when n=0, it canceled.
FS r Select Superscript and Subscript Print
Format：ASCII： FS r n
Decimal： 28 114 n
Hexadecimal： 1C 72 n
Explanation：
This command is to select the position for superscript and subscript, n=0 is superscript and n=1 is
subscript. Notice: this command is only valid for 16×8, 8 ×8 Chinese characters and 5×7 or 6×8
ASCII characters, so before using this command, the Chinese characters or ASCII characters
which are regarded as superscript and subscript for print, should be set firstly using
FS i or FS ·command.
FS SI Select Vertical DBC Case Chinese Character Print
Format： ASCII： FS SI
Decimal： 28 15
Hexadecimal： 1C 0F
To Next Page
