SAFEGUARD POWER SOLUTIONS
4. Choose and prepare proper installation location. Note: Center point distance between
left and right hangers is 15.5 inches.
Warning! Ensure UPS is located above flood and snow lines. If at any time the UPS
becomes damaged due to water or other, please consult with SPS customer care.
5. Hang the UPS on a flat surface that will adequately support the weight of the UPS (45
lbs). When replacing hanger screws, please consult with professionals to use the
proper mounting screws or bolts. If the unit is to be wall mounted, it is strongly
recommended by the manufacturer to mount on wall studs or ¾” plywood panels only
due to the heavy weight of the unit (45 lbs). SPS is not liable for any installation errors
such as improper use of mounting material and/or mounting methods.
6. Using a Phillips head screwdriver, remove the wiring cover at right side of the UPS,
connect appliance to "utility output socket", Flow Sensor to "Flow signal interface" (if
applicable), as shown below:
To Next Page
Loading...
