SPX HANKISON HIT 75 - Specifications

8
SPECIFICATIONS - Models 100 and 125
Description
Model
100 125
Operating Conditions
RatedCapacity
@125psig,8.8kgf/cm
2
*
scfm
m
3
/min
60 / 50 Hz
60 / 50 Hz
100/83
2.83/2.35
125/104
3.54/2.95
MaximumWorkingPressure 250psig(17.6kgf/cm
2
)
MaximumInletTemperature 180°F(82°C)
Min/Max.AmbientTemperature 35-110°F(2-43°C)
PressureDrop@
rated capacity
psi
(kgf/cm
2
)
60 / 50 Hz
60 / 50 Hz
3.5/2.6
(0.25/0.18)
4.6/3.1
(0.32/0.22)
Refrigeration System Data
CompressorType Hermetic,Rotary,PermanentSplitCapacitor
BTU/HR-RefrigerationOnly
@ASRE-TConditions
60 / 50 Hz 24880/19543
OutletAirTemperature
(nominal@ratedconditions)
155°F(68°C)
RefrigerantType R-22
RefrigerantCharge oz(grams)
60 / 50 Hz
SeeDryerSerialTag
SuctionPressureSetting 67psig(4.7kgf/cm
2
)
FactoryTest(design)Pressure
highside/lowside
278/144psig(19.6/10.1kgf/cm
2
)
CondenserFanSwitchSetting(in-out) 240-180psig(16.9-12.7kgf/cm
2
)
AirFlowAcrossCondenser cfm
m
3
/min
60 / 50 Hz
60 / 50 Hz
830/690
(23.5/19.5)
Electrical Data
Unit
VAC/phase/Hz
208-230/1/60
230/1/60
 Minimum/maximumvolts 187-253
 FullLoadAmpS(FLA) 11.7
 BranchCircuitFuseSize(amps) 20
Compressor
 Volts/phase/Hz
208-230/1/60
 RatedLoadamps(RLA) 10.6
 LockedRotoramps(LRA) 58.0
 Watts(input) 2415
Overload ThermalandCurrent(AutoReset)
Condenserfanmotor
 Volts/phase/Watts(output)
230/1/60
 FullLoadAmps(FLA) 1.1
OtherLoads
 Volts/amps/Watts
230/0.002/0.4
Unit
 VAC/phase/Hz
220-240/1/50
220-240/1/50
 Minimum/maximumvolts 198-264
 FullLoadAmps(FLA) 10.5
 BranchCircuitFuseSize(amps) 15
Compressor
 Volts/phase/Hz
220-240/1/50
 RatedLoadamps(RLA) 9.4
 LockedRotoramps(LRA) 38.7
 Watts(input) 2050
Overload ThermalandCurrent(AutoReset)
Condenserfanmotor
 Volts/phase/Watts(output)
230/1/50
 FullLoadAmps(FLA) 1.1
OtherLoads
 Volts/amps/Watts 220-240/0.002/0.4
* Capacity @ 180°F, 82°C inlet temperature, 160°F, 71°C inlet pressure dew point, 95°F,
35°C ambient temperature, 50°F, 10°C outlet pressure dew point, and less
than 5 psi, 0.35 kgf/cm
2
pressure drop.