SPX RADIODETECTION RD8200SG - Page 11

© 2023 Radiodetection Ltd 8
Navigating the locator menu
1 Press the key to enter the menu
2 Use the or keys to scroll through the menu
options
3 Press the key to enter the option's submenu
4 Use the or arrows to scroll through the
submenu options
5 Press the key to make a selection and return to the
previous menu
6 Press the key to return to the main operation
screen
Locator menu options
VOL Adjust the speaker volume from 0
(mute) to 5 (loudest)
SMLOG Manage survey measurements
and its communication over
Bluetooth
ILOC Enable, disable, reset or pair iLOC
connections
GPS Enable / disable the internal GPS
module and enable RTK
CDR
Perform a Current Direction (CD)
Reset. (when in CD mode)
UNITS Select metric or imperial units
TICKT Adds additional utility information
into the log data
UTIL Enable or disable utility selection
ULIST Utility Selection – Only visible if
utility section is active
LANG Select menu language
POWER Select local power network
frequency: 50 or 60Hz
ANT Enable or disable antenna modes
FREQ Enable or disable individual
frequencies
ALERT Enable or disable StrikeAlert
BATT Set battery type: Alkaline, NiMH or
Li-Ion
ARROW Select NULL or proportional
Guidance (GUIDE) arrows in
Peak+ mode
COMPA Enable or disable display of the
Compass feature
VALRT Enable or disable vibrating handle
warnings
AUDIO Set audio tone frequency level
high or low
SWING Enable or disable Swing warning
INFO Run a Self-Test, show the locator
software version and revision, set
magnetic compass (MAG-H),
display the date of the most recent
service recalibration (CAL) or the
most recent eCert calibration
(ECERT)
Table 3.1 Locator menu options
Navigating the transmitter menu
1 Press the key to enter the menu
2 Use the or keys to scroll through the menu
options
3 Press the key to enter the option’s submenu.
4 Use the or keys to scroll through the submenu
options
5 Press the key to confirm selection and return to the
previous level or exit the menu
6 Press the key to return to the main operation
screen
Transmitter menu options
VOL Adjust the speaker volume from 0
(mute) to 3 (loudest)
FREQ Enable or disable individual frequencies
BOOST Boost transmitter output for a specified
period of time (in minutes)
LANG Select menu language
OPT F Run SideStepauto™ to auto-select a
locate frequency for the connected
utility
BATT Set battery type: Alkaline, NiMH or Li-
Ion. Select Eco mode (alkaline batteries
only)
MAX P Set the transmitter to output its
maximum wattage.
MODEL Match the transmitter setting to the
model of your locator (see Appendices
for a list of all available models)
MAX V Set the output voltage to maximum
(90V)
iLOC Enable, disable or pair Bluetooth
connections (TX10B model only)
INFO Show the transmitter software version
and revision
Table 3.2 Transmitter menu options