© 2023 Radiodetection Ltd 48
11.4 Erasing measurements
The RD8200SG locator allows you to delete all
measurements. Erasing the survey measurements will
wipe the RD8200SG memory and is usually
recommended when you begin a new survey and you
have saved your previous measurements.
WARNING! Erasing measurements cannot be undone!
Proceed with caution!
To erase all stored measurements:
1 Press the key to enter the menu
2 Press the or keys to select SMLOG menu
3 Press the key to enter the SMLOG menu
4 Press the or keys to select the DATA menu
5 Press the key to enter the DATA menu
6 Press the or keys to select the DEL
7 Press the key to enter the DEL menu
8 Press the or keys to select YES
9 Press the key to make the selection and return to
the main menu
11.5 Troubleshooting
Successful wireless communication depends on a number
of factors including: battery life, electromagnetic
interference, device memory and physical obstructions.
Ensure that the RD8200SG locator and any other
compatible wireless device is sufficiently charged for
wireless communication.
Excessive electromagnetic interference can limit the
range of wireless communication and / or corrupt data.
The RD8200SG locator must be within 10m (30ft) from the
compatible paired device to maintain a wireless
connection.
Resetting connections
If you experience problems with the RD8200SG wireless
Bluetooth technology features, Radiodetection
recommends resetting the connection and then pairing
your device again.
To reset the wireless Bluetooth connections:
1 Press the key to enter the menu
2 Scroll to the SMLOG menu using the or keys
3 Press the key to enter the SMLOG menu
4 Scroll up or down to the RESET menu
5 Press the key to enter the RESET menu
6 Select YES using the or keys
7 Press the key to enter the iLOC menu
8 Re-pair your devices as described in section 10.2
Bluetooth error codes
If an error occurs when during any Bluetooth
communication between the locator and the compatible
device, the locator’s LCD will display a code to help you
resolve the problem. For the full list of codes, check
section 12.4.
To Next Page
Loading...
