© 2023 Radiodetection Ltd 9
Operation
4.1 First use
Power options
RD8200SG locators are shipped as standard configured
to use Li-Ion battery packs.
The transmitter can also be powered using good quality
rechargeable D-cell NiMH batteries or the optional
accessory Li-Ion rechargeable battery packs. It’s
important to set the correct battery chemistry in the locator
to optimize performance, see Section 4.5
Transmitters can also be powered using optional
accessory mains or vehicle power adapters. Refer to
section 13.15 for more information.
On the transmitter:
To fit the D-cell batteries in the transmitter, unlatch the
accessory tray. The battery compartment (see figure 3.2)
is located underneath the transmitter body. Use the
turnkey to unlatch the battery compartment. Insert eight
D-Cell Alkaline or NiMH batteries.
Figure 4.3 D-cell battery trays
Battery status
The locator and transmitter displays provide a battery
level indicator (refer to the diagrams in Section 3). When
battery replacement is necessary, the display shows a
flashing battery icon.
NOTE: The locator volume may automatically lower if set
to level 5 or 4, when using alkaline batteries and if their
charge is low. When this happens, the display will shortly
flash the ‘LOW BATT’ warning and show the reduced
volume level.
NOTE: Prolonged use of maximum volume and vibration
alerts on the locator will reduce battery life.
NOTE: Prolonged use of maximum volume and vibration
alerts on the locator will reduce battery life.
NOTE: Prolonged use of high power output on the
transmitter will reduce battery life.
Removing / fitting battery packs
Locator battery pack:
1 Open the battery compartment using the release
catch (figure 4.1)
2 If using a Li-Ion battery pack un-plug the lead
connector (see figure 4.7)
3 Lift the accessory cover slightly and press the battery
retaining latch inwards
Figure 4.4 Press the retaining latch inwards
4 Rotate the battery pack away and up from the latch
5 Repeat on the other side to release the battery pack
completely then lift the battery pack away
Figure 4.5 Repeat then lift the battery pack away
To fit a new battery, lift both accessory covers slightly,
then gently push the replacement pack into place until it
clicks on both sides, then close the battery pack
To Next Page
Loading...
