© 2023 Radiodetection Ltd 10
Figure 4.6 Installing a new battery pack
If using the Li-ion battery pack, plug the lead into the
battery connector (fig 4.7).
Figure 4.7 Connecting the Li Ion lead
NOTE: Fully charge your lithium-ion battery pack before
its first use
Transmitter battery pack:
1 Unlatch then remove the accessory tray
Figure 4.8 Release then remove the accessory tray
2 Turn the release catch, then open the battery
compartment
3 Release the retaining catch (fig 4.10) by pressing
gently, then lift the battery pack away
4 Line up the battery pack clips with the corresponding
recesses on the transmitter body and press into place
(fig 4.11)
5 Close the battery pack, turn the retaining latch and
replace the accessory tray
Figure 4.9: Opening the battery compartment
Figure 4.10: Press the release catch and lift the battery pack away
To Next Page
Loading...
