EasyManua.ls Logo

SPX RADIODETECTION RD8200SG - Power on; off

SPX RADIODETECTION RD8200SG
69 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© 2023 Radiodetection Ltd 11
Figure 4.11: Line up the battery pack and press into position
Charging the battery packs
WARNING! Only use charging equipment provided by
Radiodetection. The use of alternative chargers may cause a
safety hazard and/or reduce the life of the battery.
CAUTION: Do not let your battery completely discharge
as this may reduce its life or damage it permanently. If you
are not using your equipment for a long period charge
them at least once a month.
WARNING! Batteries can get hot after prolonged use at
full output power. Take care while replacing or handling
batteries.
WARNING! Do not tamper with, or attempt to
disassemble the battery packs.
CAUTION: If battery failure is suspected or if the battery
shows any sign of discoloration / physical damage return
the entire unit to an authorized repair center for
investigation and repair. Local, national or IATA transport
regulations may restrict the shipment of faulty batteries.
Check with your courier for restrictions and best practice
guidelines. Your local Radiodetection representative will
be able to direct you to our authorized repair centers.
You can re-charge your batteries using the
Radiodetection mains or automotive chargers.
NOTE: The charging temperature range is 0 to 45 °C, 32
to 113°F. Do not attempt to recharge your batteries
outside this temperature range.
Locator Li-Ion battery pack
To recharge the locator battery pack, connect the battery
charger to the DC input connector on the front of the
battery pack.
Transmitter Li-ion battery pack
To recharge the battery pack, remove the pack from the
transmitter and connect the transmitter battery charger.
Figure 4.13 Charging the transmitter Li-Ion battery pack
For more information about recharging batteries refer to
the instructions that came with your charger
4.2 Power on / off
Switch the locator or transmitter on by pressing the
key.
To switch the locator or transmitter off, press and hold the
key until the screen blanks off.
NOTE: The locator will automatically power off after 5
minutes if no keys are pressed.
Figure 4.12 Charging the locator Li-ion battery pack

Table of Contents

Related product manuals