© 2023 Radiodetection Ltd 2
Batteries
WARNING! Only use charging equipment provided by
Radiodetection. The use of alternative chargers may cause a
safety hazard and/or reduce the life of the battery.
CAUTION: Do not let your battery completely discharge
as this may reduce its life or damage it permanently. If you
are not using your equipment for a long period charge it at
least once a month.
CAUTION: thoroughly check batteries for any signs of
damage prior to first use.
WARNING! Batteries can get hot after prolonged use at
full output power. Take care while replacing or handling
batteries.
WARNING! Do not tamper with, or attempt to
disassemble the battery packs.
CAUTION: If battery failure is suspected or if the battery
shows any sign of discoloration / physical damage,
contact an authorized repair center to have the units
returned for investigation and repair. Local, national or
IATA transport regulations may restrict the shipment of
faulty batteries. Check with your courier for restrictions
and best practice guidelines.
Radiodetection representative will be able to direct you to
our authorized repair centers.
Disposal
This symbol on the product, accessories or
literature indicates that the product and its
electronic accessories (e.g. charger, headset,
USB cable) must not be treated as domestic
waste, but must be disposed of professionally. It
is your responsibility to dispose of your waste equipment
by handing it over to a designated collection point for the
recycling of waste electrical and electronic equipment.
The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve
natural resources and ensure that it is recycled in a
manner that protects human health and the environment.
For more information about where you can drop off your
waste equipment for recycling, please contact your local
city office, your disposal service or product supplier.
Please dispose of this device in a manner appropriate to
the relevant legal requirements at the end of its product
life
Batteries should be disposed of in accordance with your
company’s work practice, and / or the relevant laws or
guidelines in your country or municipality.
Wireless technology compliance
Use of iLOC wireless technology where applicable may be
subject to national telecommunication regulations. Check
with your local government authorities for further
information.
1.2 Compliance
The Declaration of conformity is available to download
from the RD8200SG cable, pipe product section page in
https://www.radiodetection.com/
For EMC and Safety compliance refer to the relevant
Technical specification document, which is available to
download from the RD8200SG cable, pipe product
section page in: www.radiodetection.com
FCC Compliance Statement
This equipment complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
The equipment may not cause harmful
interference.
The equipment must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with
the limits for a Class A digital device pursuant to Part 15
of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the manufacturer’s instruction manual,
may cause harmful interference with radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in
which case you will be required to correct the interference
at your own expense.
Modifications: Any modifications made to this equipment
not approved by Radiodetection may void the authority
granted to the user by the FCC to operate this equipment.
ISED Compliance Statements
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-
exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including
interference that may cause undesired operation of the
device.
This device complies with RF radiation exposure limits set
forth for an uncontrolled environment for portable use
conditions
Cet appareil contient des émetteurs/récepteurs sans
licence qui sont conformes aux RSS sans licence
d'Innovation, Sciences et Développement économique
Canada.
To Next Page
Loading...
