© 2023 Radiodetection Ltd 24
5.
Enter settings from the menu
6.
Click on Settings.
7.
In the devices section, ensure that the BT
modules are configured as below, where RTK-
82SG-XXXXXX is selected in the ‘GPS’ menu,
and 82SG- XXXXXX is selected in the ‘Locator’
menu.
8.
Click on the drop down next to GPS and select
Radiodetection. Then click on the right drop
down menu and select the GNSS Bluetooth
module, starting with RTK-82SG.
9.
Click on the drop down next to Locator and
select Radiodetection. Then click on the right
drop down menu and select the locator
Bluetooth module, starting with 82SG.
10.
Check the numbers match the serial number
printed on the label of your RD8200SG locator.
To Next Page
Loading...
