12
Lower Leg Removal
Place an oil pan beneath the fork to catch the draining oil. Place an oil pan beneath the fork to catch the draining oil.
Use a 5 mm extension (minimum 110 mm length) toUse a 5 mm extension (minimum 110 mm length) to loosen the rebound loosen the rebound
bottom nut and bottom bolt 3 to 4 turns.bottom nut and bottom bolt 3 to 4 turns.
Insert a 5 mm extension or hex wrench Insert a 5 mm extension or hex wrench (minimum 110 mm length)
into the bolt head of the into the bolt head of the spring sidespring side lower leg. Strike the wrench to lower leg. Strike the wrench to
dislodge the shaft from the lower leg. The bolt head should contact the dislodge the shaft from the lower leg. The bolt head should contact the
bottom of the lower leg.bottom of the lower leg.
Remove the Remove the spring side spring side bottom bolt. Clean the bolt and set it aside. bottom bolt. Clean the bolt and set it aside.
Insert a 5 mm hex wrench Insert a 5 mm hex wrench (minimum 110 mm length) into the into the rebound rebound
bottom nutbottom nut. Strike the wrench to dislodge the shaft from the lower leg. . Strike the wrench to dislodge the shaft from the lower leg.
Remove the Remove the rebound bottom nutrebound bottom nut. Make sure the crush washer is either . Make sure the crush washer is either
still in the rebound bottom nut or is no longer in the lower leg. Remove still in the rebound bottom nut or is no longer in the lower leg. Remove
the crush washer if it is in the lower leg.the crush washer if it is in the lower leg.
Clean the bolt and set it aside. Clean the bolt and set it aside.
8
Oil Pan
9
5 mm (minimum 110 mm length) 5 mm (minimum 110 mm length)
10
5 mm (minimum 110 mm length) & Mallet 5 mm (minimum 110 mm length)
11
5 mm (minimum 110 mm length) & Mallet 5 mm (minimum 110 mm length)
To Next Page
Loading...
Need help?
General
