SRAM ROCKSHOX RUDY XPLR User Manual

19
Solo Air Spring Service
Firmly pull on the air shaft to remove the air spring assembly from the Firmly pull on the air shaft to remove the air spring assembly from the
upper tube. Clean and inspect the assembly for damage.upper tube. Clean and inspect the assembly for damage.
Clean the inside and outside of the upper tube.Clean the inside and outside of the upper tube.
Inspect the inside and outside of the upper tube for damage.Inspect the inside and outside of the upper tube for damage.
NOTICE
Scratches on the inside surface of the upper tube can cause air to
leak. If an internal scratch is visible, then replace the crown steerer
upper tube (CSU).
Clamp the air shaft into the 10 mm slot in the Reverb Vice Blocks. Clamp the air shaft into the 10 mm slot in the Reverb Vice Blocks.
Use a 14 mm socket to remove the air shaft studUse a 14 mm socket to remove the air shaft stud from the air shaft.from the air shaft.
4
5
6
10 mm slot - Reverb
Vice Blocks
14 mm socket

SRAM ROCKSHOX RUDY XPLR Specifications

General

Brand	SRAM
Model	ROCKSHOX RUDY XPLR
Category	Bicycle Accessories
Language	English