INSTRUMENTS AND CONTROLS 3–23
SPEED SENSING INDICATOR
Release conditions for turning calibration
• When the adjustment switch is pressed
over 0.6 second.
• When the vehicle is not turned within 128
seconds after calibration mode started.
Warning for turning
When the vehicle has been turned out of the
specification due to external elements, direc-
tion indicator flashes to inform you that there
are abnormal signals.
The flashing interval of the road signs
changes gradually according to the vehicle
speed.
Flashing intervals by speed ranges
Flashing interval
All “ON”
per 1 second
per 0.8 second
per 0.5 second
per 0.3 second
per 0.2 second
Speed range
Less than 1.8km/h
Less than 40km/h
Less than 60km/h
Less than 80km/h
Less than 100km/h
-
CAUTION
•
Warning for turning occurs if the
abnormal signals has been re-
ceived more than 5 minutes
continuously, however, it is not the
malfunction of the vehicle and re-
turns to normal condition if the ex-
ternal magnetic field becomes to
normal.
•
The direction indicator may be de-
layed when you drive on sharp
corner, however it is normal, not
malfunction.
•
On the place where the terrestrial
magnetism is dispersed, the com-
pass may not indicate the correct
direction, however, when you leave
the place, it returns to normal.
(Examples: in the tunnel, parking
lot in a building, underground
parking lot, building complex,
above the subway lines, near to
substation, under the power lines
of the electric railways, etc.)
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:30Page 23 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
