3–38 INSTRUMENTS AND CONTROLS
CAUTION
Keep the main cruise control switch
as neutral position when not using
the cruise control.
Normal Cancellation of Cruise Control
The cruise control system will be canceled
when one or more items of the following
conditions is applied;
1. When the brake pedal is depressed.
2. When the cruising speed is downed less
than 34km/h.
3. When the off switch is operated by
pulling rearward the cruise control lever.
4. When ABD is activated.
And the cruise control system can be oper-
ated again in driving state.
• Tap down while cruise control system
is running
1. Push down the DECEL.SET. Switch of a
cruise control lever less than 0.5 sec-
ond per one switching while the cruise
control system is running. This is a tap
down switching.
2. When you operate a tap-down switching,
the vehicle is decelerated for 1km/h be-
low the previous set speed.
3. If you want to decelerate for 10km/h, op-
erate the tap-down switching ten times
without brake pedal intervention.
Recovery of Set Speed
Even if the cruise control is canceled, the
previous set cruise speed can be recovered
by pushing toward the RSM(resume) switch
of a cruise control lever when the current
vehicle speed is higher than 36km/h without
acceleration intervention. But if you turn off
the ignition switch, the memorized set speed
is cleared and you cannot recover the pre-
vious set speed.
CAUTION
The resume position should only be
used if the driver is fully aware of
this speed and wishes to resume this
particular speed.
New Rexton03_EN_RHD_일반지역.P65 2004-05-21, ¿ÀÀü 10:31Page 38 Adobe PageMaker 6.5K/Win
To Next Page
Loading...
Need help?
General
