Hardware layout and configuration UM1956
22/31 DocID028406 Rev 1
CN3
9 D6 PB1 TIM14_CH1
10 D7
(3)
PF0 -
11 D8
(3)
PF1 -
12 D9 PA8 TIM1_CH1
13 D10 PA11 SPI_CS
(4)
|| TIM1_CH4
14 D11 PB5 SPI1_MOSI || TIM3_CH2
15 D12 PB4 SPI1_MISO
Right connector
CN4
1 VIN - Power input
2 GND - Ground
3 RESET NRST RESET
4 +5V - 5V input/output
5A7PA2 ADC_IN2
(5)
6 A6 PA7 ADC_IN7
7A5
(1)
PA6 ADC_IN6 || I2C1_SCL
8A4
(1)
PA5 ADC_IN5 || I2C1_SDA
9 A3 PA4 ADC_IN4
10 A2 PA3 ADC_IN3
11 A1 PA1 ADC_IN1
12 A0 PA0 ADC_IN0
13 AREF - AVDD
14 +3V3 - 3.3V input/output
15 D13 PB3 SPI1_SCK
1. Limitations on A4 and A5, D4 and D5 related to I2C configuration are explained in Section 6.8: Solder
bridges according to SB16/SB18 setting.
2. D5 PWM on inverted channel Timer 16.
3. D7/D8 shared with OSC_IN/OSC_OUT.
4. SPI_CS is made by GPIO.
5. A7 exclusive with VCP_TX.
Table 9. Arduino Nano connectors on NUCLEO-F042K6 (continued)
Connector Pin number Pin name STM32 pin Function
To Next Page
Loading...
