To Next Page

To Previous Page

Hardware and layout UM1472

14/42 DocID022256 Rev 4

4.2.1 Using ST-LINK/V2 to program/debug the STM32F4 on board

To program the STM32F4 on board, simply plug in the two jumpers on CN3, as shown in

Figure 8 in red, but do not use the CN2 connector as that could disturb communication with

the STM32F407VGT6 of the STM32F4DISCOVERY.

Figure 8. STM32F4DISCOVERY connections image

06Y9

&1

6:'FRQQHFWRU

&1

-XPSHUV21

ST STM32F4DISCOVERY User Manual

Other manuals for ST STM32F4DISCOVERY