STA-RITE Supermax - Section 5: Restart Instructions; Priming the Pump

Section 5
Restart Instructions
If the SuperMax
®
pump is installed below the water level of the pool, close return and suction lines prior to
opening hair and lint pot on pump. Make sure to reopen valves prior to operating.
CAUTION — DONOT run the pump dry. If the pump is run dry, the mechanical seal will be damaged and the pump
will start leaking. If this occurs, the damaged seal must be replaced. ALWAYS maintain proper water
level in your pool (half way up skimmer opening). If the water level falls below the skimmer opening,
the pump will draw air through the skimmer, losing the prime and causing the pump to run dry, resulting
in a damaged seal. Continued operation in this manner could cause a loss of pressure, resulting in
damage to the pump case, impeller and seal, and may cause property damage and personal injury.
Priming the Pump
1. The pump strainer pot must be lled with water before the pump is initially started. Follow these steps to
prime the pump.
a. Remove the pump lid plastic clamp. Remove the pump lid.
b. Fill the pump strainer pot with water.
c. Reassemble the pump cover and plastic clamp onto the strainer pot. The pump is now ready to prime.
d. Open the air release valve on the lter, and stand clear of the lter.
e. Turn on the switch or time clock.
f. When water comes out of the air release valve, close the valve. The system should now be free of air
and recirculating water to and from the pool.
2. For 2-speed pumps:
a. Pump should run on high-speed for priming.
b. The pump should not run longer than 8 minutes before priming is achieved.
10
SuperMax
®
Pump Installation and User’s Guide