2 General safety instructions
06.2017 7
2 General safety instructions
You must follow the safety instructions:
National and international directives and regulations must be followed for assembly,
commissioning, operation and period tests, in particular the Machinery Directive
2006/42/EC, safety rules and country-specific safety regulations.
The manufacturer and operator of the machine / system must coordinate and observe
all applicable safety regulations with the responsible authorities on their own respon-
sibility.
Detailed instructions for commissioning and tests are described in chapter 5.
2.1 Installation requirements
For applications with the device, observe the following guidelines on electrical installation.
Switch cabinet assembly, protection at least IP54.
Implement wiring according to EN 60204-32.
The load sensor cable must be shielded. Connect the shield to earth potential.
Observe the information in the chapter "Installation".
The fuse may not exceed the value in the table "Technical data".
NOTICE
Sensor cables must be installed separately of main power cables, e.g. in spatially sepa-
rate ducts or bundles.
Unexpected start-up:
Is prevented after the power supply is restored.
The actuation control must also ensure this.
Physical injuries, e.g. crushing, severed limbs or even death.
The safety instructions are to be followed and applied!
Direct contact with the power supply:
Deadly touch voltages can arise:
from faulty wiring
from not disconnecting the power supply when working on the control equipment
Physical injuries can remain, e.g. ventricular fibrillation, skin burns.
The electrically skilled person must take this into consideration and take suitable
precautions.
To Next Page
Loading...
