ASSEMBLY INSTRUCTIONS
9
STEP 6
Attach the ROWING ARM(4) to the CENTER BEAM(2) with BUTTON HEAD BOLT(M10x1.5x80mm)(26),
WASHERS(M10)(27), and NYLOCK NUT(M10x1.5)(28). Connect the SHOCK(10) to one of the adjustment
holes on the ROWING ARM(4) and secure properly with the PULL PIN(15).
STEP 7
Insert the HANDLEBAR(6) through the tube on the top of the ROWING ARM(4). Press two HAND GRIPS(9)
onto both ends of the HANDLEBAR(6).
STEP 8
Install a AA battery into the METER(8), the battery is not included. See page 11 for detailed battery installation
instructions. Slide the METER(8) onto the plate on the ROWING ARM(4).
To Next Page
Loading...
