Stanley Dura-Glide 2000AG Series - Installing the O-Panel Breakout Switch

203729
Rev. E, 11/20/18
© 2018, THE STANLEY WORKS. ALL RIGHTS RESERVED. 5 of 18
3.3 Installing the O-Panel Breakout Switch
3.3.1 Refer to Stanley Access Technologies document No. 203590, “Dura-Glide 2000
Installation Manual,” and INSTALL the O-panel breakout switch.
Figure 2. Installing the Rails onto the Glass Panel
FLAT SIDE OF TOP
RAIL FACING UP
FLAT SIDE OF BOTTOM
RAIL FACING UP
PUSH
EVENLY TORQUE CAP
SCREWS TO 80 IN-LBS
PUSH
GLASS PANEL
PUSH
PUSH
EVENLY TORQUE CAP
SCREWS TO 80 IN-LBS
AG010
RUBBER
GASKET
WEDGE
BOTTOM RAIL
PLATE
1/4-20 X 5/8" CAP SCREW
(EVENLY TORQUE TO 80 IN-LBS)
SEE DETAIL A
DETAIL A: RAIL ATTACHMENT