INSTRUCTIONS
Insert the Receiver Base’s 3-prong plug into a grounded
outlet. If using outdoors, be sure to plug into a GFCI
approved outlet. Plug your devices into the outlets
located on bottom of Receiver Base. Using the Wireless
Transmitter, press the ON button to activate device.
OPERATING INSTRUCTIONS
MANUAL OVERRIDE
You can power the unit ON and OFF manually by
pressing the ON/OFF override button located on the
front of the Receiver. (Do not hold the button down for
manual ON/OFF operation as this will cause the unit to
enter pairing mode.)
PHOTOCELL MODE:
Photocell Mode turns OFF your device automatically at
dawn even when you forget.
1. Make sure the sliding mode switch on the
transmitter is in the photocell position.
2. Press the ON button to turn the power on. All
connected devices will turn on instantly and will
turn off automatically at dawn.
3. To cancel Photocell Mode, slide the Photocell
switch into the manual position and press either
the ON or OFF button to initiate. (Note: Sliding the
photocell switch without pressing a corresponding
function button (ON/OFF) will not initiate or cancel
the photocell function.
Item/Articulo/Article # W31184/31184/56326/56322
To Next Page
Loading...
Need help?
General
