CONTENT
PAGE
1. Safety Denitions 9
2. Specication 11
2.1 Placing Tool Specication 11
2.3 Main Components List 12
3. Tool Setup 13
4. Operating Instructions 13
4.1 Nose Equipment 13
4.2 Air Supply 14
4.3 Setting Instructions 14
5. Operating Procedure 15
6. Servicing the Tool 16
6.1 Daily Servicing 16
6.2 Weekly Servicing 16
6.3 Priming 17
6.4 Return Spring Servicing 17
7. Maintenance 18
8. Trouble Shooting Guide 22
9. Hydraulic Oil General Safety Data 23
© 2018 Stanley Black & Decker, Inc.
All rights reserved.
The information provided may not be reproduced and/or made public in any way and through any means
(electronically or mechanically) without prior explicit and written permission from STANLEY Engineered
Fastening. The information provided is based on the data known at the moment of the introduction of this
product. STANLEY Engineered Fastening pursues a policy of continuous product improvement and therefore
the products may be subject to change. The information provided is applicable to the product as delivered by
STANLEY Engineered Fastening. Therefore, STANLEY Engineered Fastening cannot be held liable for any dama-
ge resulting from deviations from the original specications of the product.
The information available has been composed with the utmost care. However, STANLEY Engineered Fastening
will not accept any liability with respect to any faults in the information nor for the consequences thereof.
STANLEY Engineered Fastening will not accept any liability for damage resulting from activities carried out
by third parties. The working names, trade names, registered trademarks, etc. used by STANLEY Engineered
Fastening should not be considered as being free, pursuant to the legislation with respect to the protection of
trade marks.
Original Instruction: E-17/010
8
ENGLISH
To Next Page
Loading...
Need help?
General
