Star Micronics IFBD-HE07X - Page 44

IFBD-HE0708 BE07 User’s Manual
3-35
3.1.12.1.SNMPCongurationParameters
ThefollowingparameterscanbesetfromwebcongurationorTelnet.
These values can also be checked at self-test print.
Name Setting range Default value
Authentic Community Max. 15 characters (ASCII) “public”
Trap Community Max. 15 characters (ASCII, Japanese OK) “public”
Trap Address (IP) 0.0.0.0 - 255.255.255.255 0.0.0.0
SysContact Max. 78 characters (ASCII, Japanese OK) None
SysName Max. 78 characters (ASCII, Japanese OK) None
SysLocation Max. 78 characters (ASCII, Japanese OK) None
EnableAuthenTrap 1 or 2 2
3.1.12.2. Trap Issue Events
When the EnableAuthenTrap setting for this product is ENABLE,
thenthisproductissuestrapstotheSNMPmanager(trapnoticationaddress)whenthefollowing3eventsoccur.
[Trap issue events]
1. When product was started up
[Generic trap type = 0(Cold Start)]
2. When printer status changed (IEEE1284 port status monitor)
[Generictraptype=6(EnterpriseSpecic)]
3. When access by an invalid committee name occurred
[Generic trap type = 4(Authentication Failure)]