Star Micronics IFBD-HE07X - 6.2 Printer Firmware Support Table

IFBD-HE0708 BE07 User’s Manual
6-2
6.2 Printer Firmware Support Table
Can be used with the F/W versions shown in the table below. (As of August 16, 2017)
Model Supports IFBD-HE07/08/BE07 Supports
IFBD-HE07X/08X/BE07X
Supports Broken Link Detection
(LED Blinking Operation,
Warnign Print Operation)
Boot Main Boot Main
TSP800II Ver1.0 Ver1.2 × × ○
FVP10 Ver1.0 Ver1.3 Ver1.0(Note1) Ver1.3(Note1)
Ver1.5(Note2)
○
SP500(Note3) Ver4.0 Ver4.0 × × ×
SP700 Ver2.0 Ver3.0 × Ver3.3(Note2) ○
TSP700II Ver2.0 Ver3.0 Ver2.0(Note1) Ver3.0(Note1)
Ver4.1(Note2)
○
TSP650(Note3) Ver2.0 Ver3.0 × × ○
TSP650II Ver1.0 Ver1.0 Ver1.0(Note1) Ver1.0(Note1)
Ver1.2(Note2)
○
TUP500(Note3) Ver2.0 Ver3.0 × × ○
TSP1000(Note3) Ver4.0 Ver3.0 × × ×
TSP828L(Note3) Ver2.0 Ver2.0 × × ×
HSP7000(Note3) Ver2.1 Ver5.0 × × ○
TCP300II(Note3) - Ver3.0 × × ×
TCP400(Note3) - Ver3.0 × × ×
○: Supported; ×: Not supported
Note 1: Only European and U.S. models
Note 2: European and U.S. models(As UTF-8 is not supported), kanji models (As UTF-8 is supported)
Note 3: Models indicated by (*3) are not supported by this product with F/W Ver. 5.0.0 and later. Use the product with F/W Ver. 4.X.X or earlier.