IFBD-HE0708 BE07 User’s Manual
1-2
1.3 Main Settings At the Time of Shipment (Overview)
The main TCP/IP settings required to use this product are outlined below.
See section “3.3 Settings and Display Items” for a list of settings that are not listed here.
1.3.1 IP Parameter Factory Shipment Settings
IP address 0.0.0.0
Sub-net Mask 0.0.0.0
Default Gateway 0.0.0.0
RARP Client Valid
DHCP/BOOTP Client Valid
1.3.2 Log-in Password oo Administrator Right Setting At the Time of Factory Shipment
If product settings are changed, use either of the protocols of HTTP (WEB), TELNET, or FTP to log-in with an account having
administrator rights for this product.
The following outlines administrator account information in HTTP (WEB), TELNET, and FTP.
Administrator Account Name “root” (required)
Password “public” (required)
* The password can be changed after logging in.
1.3.3 Log-in Password of User Right Setting At the Time of Factory Shipment
If only viewing this products settings or status information using TELNET or FTP, it is necessary to log-in with a user right account
for this product. It is not necessary to log-in to view status information using HTTP (WEB).
The following outlines user right account information in TELNET and FTP.
User Right Account Name “user” (required)
Password “guest” (required)
However, for FTP, it is possible to log-in as anonymous (any account name and password).
* The password can be changed after logging in.
1.3.4 IP Address Setting
Therearetwowaystosetthisproduct’sIPaddress.Theyarethestaticmethod(xedconditions)anddynamic(DHCP/BOOTP,
RARP, and ARP/Ping).
See section 3.1.1 Setting the IP Address” for details on the process to acquire an IP address.
Static and dynamic settings cannot both be valid at the same time. For that reason, it is necessary to disable the dynamic settings
(DHCP/BOOTP,RARP)tousestaticsettings(axedIPaddresswrittentonon-volatilememory).
Also, if the dynamic settings (DHCP/BOOTP) are valid, it is necessary to set all static settings (IP address, sub-net mask, and
default gateway) to 0.0.0.0.
When using this product, take care that when setting using HTTP (WEB), FTP or TELNET, that both of these are not valid at the
same time.
Acquired address information while operating can be checked by making a self-print when starting up the power.
To Next Page
Loading...
Need help?
General
