Star Micronics IFBD-HE07X - Page 55

IFBD-HE0708 BE07 User’s Manual
4-2
<About the StarWebPRNT SDK>
Star provides an SDK for use when creating a Web application that uses this function to perform printer control.
The SDK contains JavaScript and HTML samples that perform XML document creation and communication control between a
device and a printer etc.
Seethe“StarWebPRNTUser’sManual”ontheStarhomepagefortheSDKandtheXMLelementspecications.
Operating environment
-Web browser: HTML 5 support
In accordance with SSL/TLS support, tests were carried out by checking compatibility with F/W Ver4.0.0.
The validated compatibility results tested by Star Micronics Co., Ltd. are shown in the following table. (Results of F/W Ver4.0.0 as of
Dec. 2015)
<Conditions of the operation check>
• Star WebPRNT SDK operation
Printing and status acquisition work normally. A security error does not appear on the web browser.
• WebcongurationoperationofNIC
Changing the settings operate normally. A security error does not appear on the web browser.
All results of the operation tests must be OK with both SSL/TLS Enable/Disable.
[Windows environment]
WEB browser Windows7 Windows8.1 Windows10
Firefox (Ver:41.0.1) OK OK OK
Safari (Ver:5.1.7) OK OK OK
Chrome (Ver:45.0.2454.85) OK OK OK
Internet Explorer11 (Ver:11.0.9600.18015) OK OK OK
Microsoft Edge (Ver:20.10240.16384) OK OK OK (*1)
*1) You may need to register the printer's IP address as a "Trusted site" in the web browser settings.
[Mac environment]
WEB browser OS X V10.10.3
Firefox (Ver:40.0.0.3) OK
Safari (Ver8.0.8) OK
Chrome (Ver:43.0.2357.130) OK
[iOS environment]
WEB browser iOS 8.2 iOS 9.02
Safari (Ver5.1.7) OK OK
[Android environment]
WEB browser Andriod 4.4.2 Android 6.0
Firefox (Ver:40.0.0.3) OK -
Chrome (Ver:45.0.2454.94) OK OK
-:Unconrmeddevice
* 2017.8.16: Added information
When performing SSL/TLS communication with Chrome Ver. 58 or later, F/W Ver. 4.1.0 or later, or F/W Ver. 5.0.0 or later, is
required.