Star Micronics SM-T300I SERIES - Page 19

- 12 -
* Example:
When you want to change the settings of the printer mode as shown below,
<Before> Bluetooth/9600BPS/8DATABIT/NOPARITY/1STOPBIT/DENSITYLOW/
 LOWQUALITY/MARKNOUSE/SENSORLOW/PWDN1minSleep
<After> Bluetooth(iOS)/9600BPS/7DDATABIT/EVENPARITY/1STOPBIT/DENSITYLOW/
 HIGHQUALITY/MARKNOUSE/SENSORHIGH/PWDN1minSleep
1
PressandholdthePOWER&FEEDbuttonsfor3seconds.AftertheERRORLEDashesve
times, you can congure the settings.
Press the POWER button once and the connection mode will be changed to “Bluetooth
Mode (iOS)”.
Display: Bluetooth(iAP)
g
Bluetooth Mode
2
Press the FEED button once and then you can change the baud rate setting.
3
When the baud rate does not need to be changed, press the FEED button once again and you
can change the data bit setting. Press the POWER button once and the data bit will change to “7
bit”.
Display: 8 DATA BIT
g
7 DATA BIT
4
Press the FEED button once and then you can change the baud rate setting
.
 PressthePOWERbuttontwiceandtheparitybitwillbechangedto“EVENPARITY”.
 Display: NOPARITY
g
ODDPARITY
g
EVENPARITY
5
P
ress the FEED button once and then you can change the stop bit setting
.
When the stop bit does not need to be changed, press the FEED button once again and you
can change the print density setting.
6
When the print density does not need to be changed, press the FEED button once again and
you can change the print quality setting.
 Display: LOWQUALITYgHIGHQUALITY
5. After you have congured all of the settings, press and release FEED and MODE at the same
time. The new settings will be printed.
If the settings were not congured correctly, follow the above procedure to congure the
settings again.