Star Micronics SM-T300I SERIES - Memory Switch Settings

- 11 -
2.4 Memory Switch Settings
Change the Memory switch by following operations. (Refer to page 13 “Memory Switch Set-
ting Table”).
1. Press and hold POWER for approx. 3 seconds, and printer is turned on.
2. ToputtheprinterintoMemorySwitchSettingmode,pressandholdboththePOWER&
FEED buttons for 3 seconds. After the ERROR LED ashes ve (5) times, you can congure
the settings. Release the buttons after you surely conrm the LED ashes ve (5) times, to
get a printer into the setting mode.
3. To swith the printer mode , press FEED button.
4. If the current printer mode does not need to be changed, press FEED button again and
swith the printer mode. To change the setting, press POWER button.