- 15 -
2.5 Belt Clip
2.5.1 Attaching to the Printer
Follow the procedure below to attach the belt clip to the printer.
1. Make sure that you are attaching the belt clip in the right orientation, then screw the screw that
comes with the belt clip into the designated screw hole to attach the belt clip to the printer.
2. Use a coin to rmly screw in the screw.
2.5.2 Using the Belt Clip
When the printer is attached to your belt, you can use it like the picture below.
Hold the printer rmly with your hand when you swipe a magnetic stripe card or cut paper. If it is
not held rmly, you may fail to read card data or cannot cut paper smoothly with the tear bar.
Coin
To Next Page
Loading...
