Star Micronics TSP400 Series - Page 13

– 10 –
ENGLISH
Commands to Print Dot Graphics
Control codes
Hexadecimal
Function
codes
<ESC> “K” n <0> 1B 4B n 00 m1 m2 Print normal density graphics
m1 m2 ... ...
<ESC> “L” n1 n2 1B 4C n1 n2 m1 m2 Print high density graphics
m1 m2 ... ...
<ESC> “k” n <0> d1 ... 1B 6B n 00 d1 ... Print fine density graphics
<ESC> “X” n1 n2 m1 ... 1B 58 n1 n2 m1 ... Print fine density graphics
Commands to Print Download Characters
Control codes
Hexadecimal
Function
codes
<ESC> “&” <1> <1> 1B 26 01 01 n Define download character
n m1 m2 ... m48 m1 m2 ... m48
<ESC> “&” <1> <0> n 1B 26 01 00 n Delete a download character
<ESC> “%” “1” 1B 25 31
Enable download character set
<ESC> “%” <1> 1B 25 01
<ESC> “%” “0” 1B 25 30
Disable download character set
<ESC> “%” <0> 1B 25 00
Commands to Control Peripheral Devices
Control codes
Hexadecimal
Function
codes
<ESC> <BEL> n1 n2 1B 07 n1 n2 Define drive pulse width for peripheral
device #1
<BEL> 07 Control peripheral device #1
<FS> 1C Control peripheral device #1 immediately
<EM> 19 Control peripheral device #2 immediately
<SUB> 1A Control peripheral device #2 immediately
Commands to Control Auto Cutter
Control codes
Hexadecimal
Function
codes
<ESC> “d” “0” 1B 64 30
<ESC> “d” <0> 1B 64 00
Full-cut command to the auto cutter
<ESC> “d” “1” 1B 64 31
<ESC> “d” <1> 1B 64 01