Star Micronics TSP700 Series - Page 2

3. LED Display
Green : Lights when other party connection is recognized as 10BASE-T.
Orange : Lights when packets are received.
4. Connecting the Ethernet Cable
Note that the Ethernet cable is not provided. Please use a cable that meets specifications.
Affix the ferrite core onto the Ethernet cable to prevent radio interference as shown in
the illustration below.
1 Make sure the printer is turned off.
2 Affix the ferrite core onto the Ethernet
cable as shown in the illustration below.
3 Pass the fastener through the ferrite
core.
4 Loop the fastener around the cable and
lock it. Use scissors to cut off any
excess.
5 Connect the Ethernet cable to the
connector on the interface board. Then,
connect the other end of the cable to
your computer.
5. Installing the Printer Driver and the LPR Port Driver Set
To use the Ethernet interface from Microsoft’s Windows 95/98 and ME, the“Star LPR
Port Driver Set” along with the printer driver is necessary.
Download the Printer Driver and the Star LPR Port Driver Set from thefollowing Web site.
Printer Driver URL : http://www.star-micronics.co.jp/service/frame_sp_spr_e.htm
* To use Windows NT 4.0/2000/XP, the “Star LPR Port Driver Set” is unnecessary.
10cm
(
Maximum
)
Fastener
Ferrite core
Ethernet cable