Star Trac E-TRxe Quick Start Guide

18 pages

To Next Page

Service Menu

STAR TRAC FITNESS 1 of 8 637-1414 Rev: A

TV Setup and Troubleshooting

E-TRe & E-TRxe

The following procedure will guide you through the Channel Scan of the Embedded E-TRe and E-TRxe treadmills.

Step 1

Start on the default screen (Fig. 1).

Fig. 1

Step 2

Press and hold the VOL ‘+’ key and the CH ‘+’ key and the number ‘3’

key on the keyboard at the same time to enter the Service Menu (Fig.

2).

Fig. 2

VOL

Step 3

Press the number ‘5’ key on the keyboard or touch “Calibration And

Setup”.

Other manuals for Star Trac E-TRxe

B
Betty MitchellAug 16, 2025
What to do if the Star Trac Monitor shows an emergency stop condition?
- R
  rachelgarciaAug 16, 2025
  First, reset the E-Stop switch to make the product operational. If the problem remains, inspect the cables and connections within the Hot Bar, including the e-stop cable connecting the Hot Bar to the FitCPU. If issues continue, examine the communications cable linking the FitCPU and the Translator Board. Should all these components appear functional, consider replacing the Translator Board.
W
waltersjoeAug 19, 2025
How to fix timeout during start-up hand shaking on Star Trac Monitor?