2.1.2 Charging the Battery
Insert the battery pack into the printer to charge it.
Plug in socket with USB charging.
When battery pack runs out of power, the battery icon will flash. It powers off automatically when continues
printing. If you want to go on, please charge it.
Battery charging status descriptions are as follows:
While Charging Charging is completed
When power ON Power lamp is Flashing in green
Power lamp is constant on
*But if printer goes into Stand-by
mode, power lamp will keep flash
1 time/second.
When power OFF Power lamp is Flashing in green Power lamp is off
NOTE: However, a low-grade car charger may cause a trouble due to a sudden change of voltage.
Use the charger that satisfies the USB standard.
Charging via PC.
USB Cable
(Standard Accessory)
To Next Page
Loading...
Need help?
General
