Table 5-1 General Specification(Continued)
( 2/2 )
Item Parameter
Charging
USB charge
Output DC 5V 0.5A,Time required for full charge:
5H
Power supply
Battery 1700mA 3.7V rechargeable battery pack
Battery
operating time
Approximately 13 hour printing (12 receipts per hour with
sleep mode)
OLED 128 x 64 dots with Blue Backlight
MSR
(Single Head)
MSR model only
Format
ISO 7810, ISO 7811, ISO7812 1st, 2nd and 3rd Track/ JISII
Track Reading
Security AES or 3DES encryption. DUKPT Key Management
Paper
Paper type Thermal paper
Paper width
57.5±0.5mm
Paper thickness
0.053mm≤X ≤0.12mm
Roll paper diameter
13mm≤Ø≤40.5mm
Recommended paper P220AG, PD450, FD200, Alpha 400-2.1
Physical
characteristics
Operation condition 0°C to 50°C, 20% to 85%RH
Charging condition
0°C to 40°C, 0~10℃ *1
Storage condition -20°C to 60°C, 5% to 95%RH
Dimension 86(W) x 122.5(D) x 46(H) mm
Weight 220g (including battery pack)
Reliability TPH
50km(not more than 12.5% printing density)/100 million
pulses
Software Emulation StarPRNT mode
*1. When the printer is used in a low temperature environment (less than 10 degrees), the battery’s
performance will be diminished, and the amount of time that you can use the printer for may be reduced.
WARNING:
Pls.use the recommended thermal paper or same quality paper, otherwise it will influence the printing quality
and decrease the thermal print head life.
Pls. Use at a room temperature if you want to set the print density to “Special”.
Some types of the paper are not suitable for use in low-temperature environment.
To Next Page
Loading...
