3
© 2019. All rights reserved.
WARNING
• Extension cords may not deliver sufficient voltage to the pump motor. Extension cords present a
life threatening hazard if the insulation becomes damaged or the connection ends fall into water.
The use of an extension cord to power this pump is not permitted.
• Secure the discharge line before starting the pump. An unsecured discharge line will whip,
possibly causing personal injury, and/or property damage.
• Ensure that the electrical circuit to the pump is protected by a 15 amp fuse or circuit breaker.
• Release all pressure and drain all water from the system before servicing any component.
• Wear safety goggles at all times when working with pumps.
• The unit is designed only for use on 115 volts (single phase), 60 Hz, and is equipped with an
approved 3-conductor cord and 3-prong grounded plug. Do not remove the ground pin under any
circumstances. The 3-prong plug must be directly inserted into a properly installed and grounded
3-prong, grounding-type receptacle. Do not use this pump with a 2-prong wall outlet. Replace the
2-prong outlet with a properly grounded 3-prong receptacle (a GFCI outlet) installed in accordance
with the National Electrical Code and local codes and ordinances. All wiring should be performed
by a qualified electrician.
• Protect the electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the
cord. Do not use damaged or worn cords.
DANGER
• Do not pump flammable or explosive liquids such as oil, gasoline, kerosene, ethanol, etc. Do not
use in the presence of flammable or explosive vapors. Using this pump with or near flammable
liquids can cause an explosion or fire, resulting in property damage, serious personal injury, and/
or death.
• Always disconnect the power to the pump before servicing.
• Do not touch the motor housing during operation. The motor is designed to operate at high
temperatures. Do not disassemble the motor housing.
• Do not handle the pump or pump motor with wet hands or when standing on a wet surface, or in
water.
CAUTION
• Do not lift the pump by the power cord.
• Know the pump and its applications, limitations, and potential hazards.
• Follow all safety standards and all local electrical codes.
SPECIFICATIONS
Power Supply 115V, 60Hz., 15 Amp Circuit
Liquid Temp Range 32°F to 120°F (0°-50°C)
Pump Inlet 1-1/2 in. NPT
Pump Discharge 1-1/4 in. NPT
To Next Page
Loading...
Need help?
General
