Star TSP100III Series - Safety Symbols and Notices; Caution Symbols Explained; Trademark Acknowledgments; Manual Usage Notice

Caution Symbol
These symbols are located near the thermal print head.
Because the thermal print head is hot immediately after printing, do not touch
it. Static electricity can damage the thermal print head. To protect the thermal
print head from static electricity, do not touch it.
This symbol is located near the cutter.
Never touch the cutter blade, as you could injure your ngers.
This symbol is located near the peripheral drive connector.
Do not connect this to a telephone.
Trademark acknowledgments
TSP800II: Star Micronics Co., Ltd.
Notice
• All rights reserved. Reproduction of any part of this manual in any form whatsoever, without STAR’s express
permission is forbidden.
• The contents of this manual are subject to change without notice.
• All eorts have been made to ensure the accuracy of the contents of this manual at the time of going to press.
However, should any errors be detected, STAR would greatly appreciate being informed of them.
• The above notwithstanding, STAR can assume no responsibility for any errors in this manual.
• IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.
• Android is a trademark of Google Inc.
• Windows is registered trademarks of Microsoft Corporation.
• The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
Copyright 2009-2020 Star Micronics Co., Ltd.