Star TSP100III Series - 3-7. Bluetooth Settings

– 19 –
PAIR
RST
PAIR
RST
PAIRRST
PAIR button
PAIR buttonRST button
LED
3-7. Bluetooth Settings
(For
Bluetooth Interface Models only
)
(3) Pairing will be possible for 60 seconds from when the LED begins ashing green.
During this time, execute "Search for devices" from the master device and tap the relevant
device from the displayed list.
Device name: Star Micronics (default)
(4) In an iOS device, after pairing, the LED will automatically begin ashing blue, and the
printer will be automatically connected. In an Android device, the LED turns blue only
while data is sent.
(5) Connect to the printer from the master device application and perform printing. If the
printing is successful, the pairing process has been completed.
Pair the printer with the master device by following the procedure below.
3-7-1. Pairing using SSP (Simple Secure Pairing) [Default]
(1) Working on the master device, tap [Settings] and set [Bluetooth] to ON.
<
LED
>
Indicates the status of the Bluetooth interface.
Green (on): Not connected.
Green (ashing): Ready to start pairing.
Blue (on): Connected.
Purple (ashing): Auto connection ON.
Flashing green LED
(2) After turning the printer's power switch on, press and hold the PAIR button on the rear
interface of the printer for 5 seconds or more, and then release it. The LED will ash green.
<
iOS > < Android >