Starfire SF-2400 User Manual

BeiJing Starfire Control Technology Co.,Ltd WeChat:18901200180 QQ: 1908817881
7
【F】Cutting speed: set the automatic cutting speed.
【T】Preheating time: set the preheating delay.
【N】Slot: the slot size can be set before the cutting operation starts.
【0】Continuous walk: after the function is turned on, press the direction button when manually moving the gun, the
cutting gun will keep walking, and then press the direction button or pause button again to stop.
【 】：Start cutting;
【 】：Pause or stop cutting.
2.2 Manual function description
Under the main screen, press [F2] to enter the manual screen, as shown in the figure below：
[F1] plate calibration: press this key to enter the plate calibration screen.
Steel plate calibration: after entering the rotation calibration interface, move the cutter to the starting position of
plate processing, press [F1] to set the starting point, and the system coordinates will automatically reset, and then
move the cutter to another corner of the same side of the plate, and press [F2] to set the end point, and the system
will automatically rotate the graph. After the correction is completed, the system prompts whether to return to the

Starfire SF-2400 Specifications

General

Brand	Starfire
Model	SF-2400
Category	Controller
Language	English