BeiJing Starfire Control Technology Co.,Ltd WeChat:18901200180 QQ: 1908817881
16
Cutting mode [G] : press the keyboard key to switch the cutting mode between flame, plasma and
demonstration.
Cutting speed [F] : press the keyboard key , change the value to change the cutting speed, and
press enter to confirm.
Manual speed [X] : press the keyboard key , change the value to change the cutting
speed, and press enter to confirm.
Slot [N] : press the keyboard key , change the value, change the slot size, and press enter
to confirm.
Preheating delay [T] : press the keyboard key , change the value behind to change the preheating
delay, and press enter to confirm.
3.2.2 press the space on the main interface to enter the processing interface
：The blank space key
[F1] fallback: the cutting nozzle returns along the original path (at this time, only a blank line is left without cutting);
[F2] advance: the cutting nozzle advances along the cutting path (only blank line, no cutting);
[F3] return parameter: the cutting nozzle returns to the starting point, that is, the starting point of the current
workpiece;
[F4] select perforation point: after selecting the perforation point, the cutter will automatically move to the selected
perforation point.
[F5] graphic amplification: enlarge graphics;
[F6] increase delay: increase the preheating time by 15 seconds at a time.
[F7] reduce the delay: reduce the preheating time, skip the remaining preheating time, note: the system does not
remember the preheating time.
3.2.3 start processing
To Next Page
Loading...
Need help?
General
