ASSISTANCE menu
5
3. ASSISTANCE MENU
Accessing the “ASSISTANCE” Menu
To access the ASSISTANCE Menu, follow the same procedure as for the MANUFACTURER Menu, keying "111" or
other preset password.
This gives access to the entire User menu and some functions which have been enabled on the Manufacturer menu.
Access the ASSISTANCE menu as follows:
Note: some options will not be displayed if they are not enabled.
FASE ACTION DISPLAY NOTE
1 Switch off the control unit [ ]
2 Switch on the control unit, keeping
the _m_and _h_ keys pressed until
the Display prompts for a password
[STARTEC]
[ R.S.26O ]
[VER 1.18]
[--------]
[PWD ---]
- Manufacturer’s name
- Model of machine
- Program version
- If the password is not entered within 5
seconds by pressing a +/- key, the machine
goes into working mode
3 Press the Initial Pause _+_ or _-_
keys to display the 1st digit.
[PWD 1--] e.g. password = 111
4 Press the Speed _+_ or _-_ keys to
display the 2nd digit.
[PWD -1-] e.g. password = 111
5 Press the Final Pause _+_ or _-_
keys to display the 3rd digit.
[PWD --1] e.g. password = 111
6
Press the _START_ key
[MN ASSIS] - Menu Assistance
7 Displayed a few seconds after
releasing the _START_ button
[OK MENU] - access to the menu enabled
8 Displayed in the event of password
error
[ERR PWD] - Password error. Repeat procedure for stage 1
9
Pressing the _v_ key appears
[VLV OUTL] Position of the valve for stopping work
10 Press the _v_ cursor key again to scroll through the following menu options
DISPLAY DESCRIPTION
[VLV YES] o [VLV NO] Valve for starting/stopping work: ACTIVE or INACTIVE.
[WI O:OO] Waiting start Irrigation. The waiting time, in hours and minutes, can be set
by using the second function of the H key.
[ SECTORS] If it is enabled, it permits the management of irrigation up to 8 different
speeds (sector irrigation). With more than 0 sectors, it is possibile to set
the maximum running time of irrigation.
[NoSTP mO] o [STOP mO] No Stop at metres = 0. Rewinding continues until the signal from the End
Rewind sensor (the display may show negative metres).
Or, STOP at metres = 0. Rewinding stops when the machine indicates m.
of pipe = 0.
[OUTPUTS ] Management of output sources: OU1, OU2 and OU3 (the last one appears
on RAIN V.03 boards and following models).
[ INPUTS ] Management of input sources: IA1, IA2, IA3 and 4-20mA.
Reminder: the inlets IA1, IA2, IA3 are activated when they are switched to
ground through a signal or a contact.
[UM METRI] or [UM FEET] Units of Measurement: decimal METRIc system.or, Imperial (US)
measuring system.
[LANG ITA] , [LANG FRA] ,
[LANG ENG] or [LANG GER]
Language used for display.
To Next Page
Loading...
Need help?
General