MANUFACTURER menu
7
4. MANUFACTURER MENU
Accessing the “MANUFACTURER” Menu
To access the MANUFACTURER Menu, follow the procedure described in the following stages:
Note: some messages may not appear because the functions are not enabled.
STAGE ACTION DISPLAY NOTE
1 Switch off the control unit [ ]
2 Switch on the control unit, keeping
the _m_and _h_ keys pressed until
the Display shows the message
"MENU"(after several seconds) and
prompts for a password
[STARTEC]
[ R.S.26O ]
[VER 1.18]
[PWD ---]
- Manufacturer’s name
- Model of machine
- Program version
- If the password is not entered within 5
seconds by pressing a +/- key, the machine
goes into working mode
3 Press the Initial Pause _+_ or _-_
keys to display the 1st digit.
[PWD 2--] e.g. password = 222
4 Press the Speed _+_ or _-_ keys to
display the 2nd digit.
[PWD -2-] e.g. password = 222
5 Press the Final Pause _+_ or _-_
keys to display the 3rd digit.
[PWD --2] e.g. password = 222
6
Press the _START_ key
[MN MANUF] - MeNu MANUFacturer
7 Displayed a few seconds after
releasing the _START_ button
[OK MENU] - access to the menu enabled
8 Displayed in the event of password
error
[ERR PWD] - Password error. Repeat procedure for stage 1
4.1 Selecting and loading a model
9 Press the _>_ cursor key, the
following is displayed
[CMOD 17] - e.g. model code in position 17
10 Press the _v_ cursor key, the
following is displayed
[STARTEC] - e.g. constructor name
11 Press the _^_ cursor key to return
to the previous screen
[CMOD 17] - e.g. model code in position 17
12 Press _ENTER_ [CMOD* 17] - The asterisk is displayed, enabling changes
13 Press _h_. The model
corresponding to position 17 is
displayed
[S4OOX125] - e.g. STARTEC model with 400 m length, 125
mm diameter tube
14 - Press the _^_ or _v_ cursor keys
to scroll through the entire list of
your models and default STARTEC
models
- Press the _>_ or _<_ cursor keys
to skip 10 positions
[S5OOX1OO] - irrigator model
15 Displayed if no keys are pressed [CMOD* 17] - Model position
16 Press _ENTER_ to load the
parameters for the selected model
[R MO OK] - Parameters successfully loaded
17 Press the _<_ cursor key to check if
the data for the selected model has
been loaded. Use the cursor keys to
scroll through the menu options
[VLV SCAR] - the first menu option is displayed
18 If all changes are correct, Save changes, otherwise Cancel changes.
To Next Page
Loading...
Need help?
General