Instruction manual
11
Asssembly
Warning! Assembling this product requires multiple people. DO NOT attempt to
assemble this product and install equipment without assistance.
Assemble the base
1. Insert the base into the left leg, aligning the holes in the base with the holes in the
left leg.
2. Insert two M6x16 mm screws through the left leg and into the base.
3. Use the hex key to tighten the M6x16 mm screws.
4. Repeat steps 1 to 3 to attach the right leg. (gure 1)
gure 1
Right leg
Left leg
Base
M6x16 mm screw
Hex key
To Next Page
Loading...