The MCU3 & 4 Manuals
The MCU3 & 4 Environmental Monitoring Systems have a range of manuals covering various
aspects of their operation:
• MCU3 & 4 Installation and Hardware Configuration Manual
This manual covers all of the hardware aspects of the MCU Environmental Monitoring
Systems. Each of the component parts of the system is discussed and hardware
configuration is explained. Dimensional drawings are included.
• MCU3 & 4 Software Configuration and System Calibration Manual
The operation of the MCU system is discussed as well as the software configuration
and calibration procedures.
• ‘Mentor PC’ Operators Manual
The Mentor PC software is discussed including:
Software Installation
Hardware Configuration to facilitate downloading logged data and
configuration via a PC.
Displaying, and archiving logged data.
Important
Status Scientific Controls strive to continually improve their products in line with customer’s
requirements and technological advancement. Status Scientific reserve the right to modify
the design of the system at any time.
Due to continual improvement not all of the features described within this manual may be
available on earlier models, contact Status for further details.
This manual covers all MCU Control Units containing Input Boards fitted with jumper switch
configurable options. If the configuration of the Input Boards is set by the removal or fitting
of jumpers then please refer to an Issue 2.0 manual available from Status Scientific
Controls.
To Next Page
Loading...