8.7 Mounting Details for FGD3 Detector Heads
The diagram below shows the mounting centres for the Status Scientific Controls FGD3 Detector
Heads.
Depth = 75mm approx.
All dimensions are in ‘mm’ and are approximate only.
Note: The front panel/lid of the detector head opens to allow access to the screw terminals
situated inside. Sufficient space should be allowed around the mounting position so
that this action is not restricted.
Two mounting slots are provided, suitable for M6 fasteners.
Fixings Required:
2 off M6 Fasteners
(Rawl Bolts or similar dependent on mounting wall construction)
To Next Page
Loading...