STC micro U8W - 4.5 Use STC Universal USB to Serial Tool to Simulate User Code

- 37 -
STC8H Series Manual
4.5 Use STC universal USB to serial port tool to simulate user
code
The current STC simulation is based on the Keil environment, so if you need to use the STC universal USB to serial
port tool to simulate user code, you must install the Keil software.
After the Keil software is installed, you also need to install the STC simulation driver. The installation steps of STC's
simulation driver are as follows:
Firstly, open STC-ISP to download the software;
Then click the "Add MCU Type to Keil / Add STC ICE driver to Keil" on the "Keil ICE settings" page in the
functional area on the right side of the software:
STC Tool Instruction Manual