Steamfast SF-162 - Steam Mop Assembly Guide; Initial Steam Mop Setup; Extension Pole Assembly; Mop Head and Accessory Attachment

6
|
ENGLISH
STEAM MOP SETUP
Remove all packaging materials from each piece before assembling the unit.
EXTENSION POLE
1. Open the Adjustment Lever and adjust to desired length and then close the Lever to lock
height into place
2. Insert the bottom of the Extension Pole (the side without the handle) into the body of the
unit, until it “clicks” securely into place.
MOP HEAD & ACCESSORIES
CAUTION: Always allow unit to cool before connecting/disconnecting any accessories.
1. Lay Microber Pad on at surface, with two fastener strips facing upward.
2. Align Mop Head above Microber Pad. Press Mop Head rmly down onto Microber Pad.
CAUTION: Use care when handling a recently used Microber Pad, as it may still be hot.
NOTE: Microber Pads are machine washable. To avoid picking up lint, washing
separately from other fabrics is recommended. Only use liquid detergent. Avoid using
any fabric softeners or bleach. Air drying is recommended; machine drying on a low
setting is acceptable as well.
3. To use Carpet Glider, rst attach Microber Pad following steps listed above.
4. Lay Carpet Glider on at surface, with clasps facing up.
5. Align Mop Head above Carpet Glider and press Mop Head onto Carpet Glider until it
“clicks” securely into place.
Assembling Your Steam Mop