XT-3200/3300/3600/4600
4800/5600/5700 Treadmill
TENSIONING THE BELT
RUNNING BELT
If when you plant your foot on the belt, you can feel a sliping sensation then
the belt has been stretched and is slipping over the roller. This is normal
and common adjustment on a new treadmill. To eliminate this slipping,
tighten both sides of the rear roller by wing a Allen wrench turn 1/4 of a
TURN as shown above. Try the treadmill again to check
for slipping. Repeat if necessary, but
NEVER TURN the roller bolt more
than 1/4 turn at a time.
CAUTION: OVER TIGHTENING OF THE ROLLER WILL
SEVERELY SHORTEN THE LIFE OF THE BELT
AND MAY CAUSE FURTHER DAMAGE TO
OTHER COMPONENTS.
DRIVE BELT
If you have tightened the running belt and are still experiencing a slipping
sensation, call your STEELFLEX dealer. Tightening of the drive belt should
only be performed by an authorized dealer.
To Next Page
Loading...
